RN2903 channels being re-enabled

Setup and configuration
1

I’m having a problem with enabling/disabling channels on the 2903. Initially I disable all the channels, then re-enable channels 8-15 (corresponding to the channels enabled on the Laird gateway). All this has been working, until I enabled ADR.

Now, immediately after config, chans 0-7 are off, but after the first downlink from the server, chans 0-7 are turned on.

I have chans 8-15 in the gateway-profiles, and factory-preset frequencies 903.9MHz to 905.3MHz in the device-profile.

Any idea why chans 0-7 are being re-enabled?

Apologies if this was handled in another topic.

2

It appears that editing the .toml file to specify the channels and rebooting fixes the problem, while making the changes only in the portal doesn’t.

I haven’t confirmed this yet, but editing the .toml file directly did appear to fix the channel problem.

It also appears that changes in the portal aren’t written to the .toml file?