Hi
So far I seem to have LoRaServer working with my Pi + RAK831 + MKR WAN 1300.
I just wanted to try make sure I have everything configured correctly. Inside global_conf.json there’s a variable called antenna_gain and by default it’s 0. My fiberglass antenna has a sticker on it that read 3.5dBi. I tried putting 3.5 in it and restarting the packet-forwarder but it doesn’t seem to let my Arduino reconnect unless I restore the value to 0. So I wasn’t sure what is going on. Just wondering if anyone knew what to do with that value?
Also if possible, could anyone confirm these values I have set that I’ve found on the internet? Not 100% sure they’re correct for my region (AU915 - Sydney AU) but I think they are!
Service Profile:
- Add Gateway Meta-data: Yes
- Device status request frequency: 0
- Minimum allowed data rate: 0
- Maximum allowed data rate: 13
Device Profile:
- MAC Version: 1.0.2
- Regional Parameters: A
- Max EIRP: 30
Gateway:
- Enabled Channels: 0, 1, 2, 3, 4, 5, 6, 7
Thank you!